To Set The Product In Operation Position; To Set The Cutting Height; Battery Status - Husqvarna LC 247i Manual De Usuario

To set the product in operation position

1. Fold the handle to upright position.
2. Move the knobs up in the direction of the handle until
they stop and you hear a click.
3. Tighten the knobs fully.
WARNING:
unless the handle is fully folded up and set
in one of the applicable height positions.
To adjust the handle on page 10 .
Refer to

To set the cutting height

The cutting height can be adjusted in 6 levels.
1. Move the cutting height lever down to decrease the
cutting height.
12
Do not operate the product
2. Move the cutting height lever up to increase the
cutting height.
CAUTION:
too low. The blades can hit the ground if the
surface of the lawn is not level.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Operation of the bat-
tery
Charging of the bat-
tery

Battery status

The display shows the remaining battery capacity and if
there are problems with the battery. The battery capacity
is shown for 5 seconds after the product is switched off
or the battery indicator button is pressed. The warning
symbol on the battery is on when an error has occurred.
Battery on page 19 .
See
Do not set the cutting height
Before you use the battery,
Ambient temperature
5 °C - 40 °C
5 °C - 40 °C
1696 - 003 - 16.12.2021