Sportplus SP-HT-9600-iE Manual De Instrucciones página 19

6. ASSEMBLY INSTRUCTIONS
STEP 3
20
22
21
25
37
5
1. Remove the hex screw (22) and clamp (25) from the handlebar tube (4).
2. Fasten the handlebar (5) to the handlebar tube (4). Use the previously removed hex screw (22)
and clamp (25).
3. Put on the handlebar cover (37) and fasten with the T-shaped set screw (21).
4. Guide the hand pulse cable (20) through the grommet (32) and pull it up into a vertical
position.
5. Loosen the 4 screws (27) on the back of the computer (6).
6. Connect the upper computer cable (33) and the hand pulse cable (20) to the connections
on the back of the computer (6).
7. Place the computer (6) on the computer mount. Secure the computer with the 4 screws (27)
removed earlier.
8. You can readjust the handlebar position using the T-shaped set screw (21) at any time.
SP-HT-9600-iE-IM-INT-V04.indb 36-37
33
6
27
32
4
36
6. ASSEMBLY INSTRUCTIONS
STEP 4
39
13
11
38
1. Put the cover (12) on the saddle guide tube (13) and fasten using the screws (39) that are
premounted to the saddle guide tube.
2. Loosen the nuts (A) underneath the saddle (8). Then mount the saddle to the saddle guide
tube (13) and fasten using the nuts. See detailed image.
3. Insert the adjustable saddle support (7) through the lower saddle guide cover (38) into the
flywheel frame (1). Set to the desired height and lock using the set screw (11). Fasten firmly.
4. You can adjust the height of the saddle support up or down by loosening the set screw (11)
and pulling out/pushing in the saddle support. The user could adjust the saddle backward
and frontward as well by adjusting the knob (36).
8
12
7
A
7
1
37
3/31/17 3:16 PM