PART DESCRIPTION
PART
PART NAME
A
Electric Motor and Air
Compressor Pump
B
ON/OFF Switch
C
Air Line Outlet
D
Regulated Pressure Gauge
E
Tank Pressure Gauge
F
Air Pressure Regulator
G
Pressure Relief Valve
H
Air Tank
I
Drain Valve
J
Power Cord
All manuals and user guides at all-guides.com
The motor is used to power the pump. The pump is
used to compress the air and discharge it into the tank
via the piston moving up and down in the cylinder.
This switch turns on the compressor and is operated
manually. When in the ON position, it allows the
compressor to start up or shut down automatically,
without warning, upon air demand. Always set this
switch to OFF when the compressor is not being used
and before unplugging the compressor.
The outlet is used to connect the 1/4 in. NPT air hose.
The gauge is used to measure the regulated outlet
pressure.
The gauge is used to measure the store air pressure
level of the tank. It is not adjustable by the operator, and
does not indicate line pressure.
The regulator is used to adjust line pressure to the tool
you are using. Turn the knob clockwise to increase
pressure and counterclockwise to decrease pressure.
The valve is used to prevent system failures by relieving
pressure from the system. When the pressure reaches
the preset level, the pressure switch will not shut down
the motor, it will automatically pop open or you can pull
the ring on the valve to open.
The tank is used to store the compressed air.
The drain valve is used to remove moisture from the air
tank after the unit is shut off.
This product is for use on a nominal 120-volt circuit
and should be grounded. A cord with a grounding plug
must be used. Make sure the product is connected to
an outlet having the same configuration as the plug. No
adapter should be used with this product.
4
PART DESCRIPTION
Grounded
outlet
Plug
Grounding Pin
kobalttools.com
Lowes.com