Zeegma Zonder Klaar Manual De Usuario página 10

3. Selected working mode
EN
4. Tank level and/or filter clogging indicator
5. Brush locking indicator
6. Change of working modes
How to empty the dust bin
Before you empty the bin, switch the device off. Press the bin flap
releasing key and empty it. Use the device only if the dust bin has been
properly installed (fig. 7).
How to replace the rotating roll (fig. 8)
ҋ Unplug the device.
ҋ To remove the roll, hold the side switch at the bottom of the turbo
brush, a side valve will pull out. Take it out and then take the round
roll out.
ҋ
Insert the roll to install it, and then lock the valve in the turbo brush.
Note! Pay attention to precise installation of the round brush. Wrong
installation may cause the brush to malfunction (fig. 9).
How to clean and maintain (fig. 10)
ҋ
Before you start cleaning, unplug the device.
ҋ
To remove the dust bin, pull the trigger (marked in fig. 10) and pull
the tank out.
ҋ Remove the microfiber filter, unscrew and take the filtration system
out – wash under running water.
ҋ HEPA filter is at the back of the device – do not wash in water,
replaceable filter.
ҋ
Wash the interior of the dust bin under running water, clean the
remaining part of the device with a wet cloth.
ҋ
Wipe the dust sensor with a wet cloth.
ҋ
Use only dry parts and filters.
ҋ If you can notice that the suction power drops, clean filters in the
first place.
ҋ Do not make the device dry off in the sunlight or in humid area.
ҋ To put the dust bin back, put the bin until you can hear a „click".
Important! Do not wash filtering elements in the washing machine and
do not dry them with a hair drier.
Note! Do not use the brush to wash filters. Make sure you do not damage