Troubleshooting - Zeegma Zonder Klaar Manual De Usuario

the filter refill. Make sure all pieces are dry before you put them into the
vacuum cleaner.
Important! Regularly wash filters and use a wet cloth to wipe the dust
sensor which is responsible for regulation of the flow in auto mode.
*Dust sensor is located in the hollow, under the dust bin (fig. 11).

Troubleshooting

Problem
The product does not
work
The vacuum cleaner has
no suction power or its
power is low
The battery does not
charge
The charging light does
not glow
Air coming out of the
vacuum cleaner emits
an unpleasant odor
The pictures are for reference only. The real design of the products may differ from the
Cause
Storage battery is flat
Storage battery life is over
Damaged motor
Filter in the device is clogged
up
Dust bin is full
Dust bin is not properly
installed
Replaceable roll is blocked
HEPA filter must be replaced
Poor contact between the
device and a docking station
Storage battery stopped
working
The docking station is not
connected to power supply.
Filter is not clean
During the first few cycles
of operation, the device may
emit a smell of plastic. It is
a normal phenomenon
pictures presented.
Solution
Charge the storage battery
Replace the storage battery
Contact the manufacturer
Carefully wash the filter
under running water.
Precisely dry off before use
to make sure bacteria do not
grow
Empty the dust bin
Install the dust bin correctly
Clean the replaceable roll
Buy a new HEPA filter and
replace it very 6 months
Do not touch or move the
docking station as long as
you can see a charging light.
Change the charging
method, connect the device
straight to the charger
Contact the manufacturer
If the cable is connected to
power supply, make sure it is
not damaged
Wash the filter and dry
the filter off before use to
prevent growth of bacteria or
replace the filter
The smell of plastic will
vanish after some time
EN