Char-Broil Perfomance Guía Del Producto página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ignitor Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. To ignite, push and turn burner knob to HIGH. Immediately,
push and hold ELECTRONIC IGNITOR button until the burner
lights.
5. If ignition does NOT occur in 5 seconds, turn the burner
controls off
, wait 5 minutes and repeat the lighting
procedure.
6. Repeat steps 4 and 5 to light other main burners.
WARNING
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner
controls
off, wait 5 minutes and repeat the lighting
procedure. If the burner does not ignite with the valve
open, gas will continue to flow out of the burner and
could accidently ignite with risk of injury.
Match-Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place match into match holder (hanging from side panel of
barbecue). Light match; then light burner by placing match
through the match light hole on side of barbecue. Immediately
push in and turn burner knob to the
burner lights and stays lit.
5. Light adjacent burners in sequence by pushing knobs in and
turning to the
HIGH position.
(off).
(off).
HIGH position. Be sure
NOTE: Your barbecue may NOT be equipped with a
Sideburner!
Sideburner Ignitor Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Turn sideburner knob to the
ELECTRONIC IGNITOR button.
5. If sideburner does NOT light within 5 seconds, turn knob
to
off, wait 5 minutes, then repeat lighting procedure.
Sideburner Match Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place lit match near burner. Immediately turn sideburner
knob to the HIGH position. Be sure burner lights and stays
lit.
7
(off).
HIGH position, push and hold
(off).

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

467301215

Tabla de contenido