Installation Details - Burda RELAX DARK IRC IP55 Uso Y Mantenimiento

INSTALLATION DETAILS:

1. Drill four holes in the wall as
shown below.
2. Fix the two supports to the
wallt using dowels of appropri-
ate size. The dowels should be
able to hold at least 5 times the
radiant heater.
3. Make sure that the wall to
which the device is supposed to
be attached is stable and there
are no power lines or water
pipes.
Instructions
The heater must not be
directed towards the ceiling
or flammable materials.
The device must not be
mounted into the ceiling.
You must leave enough
space around the top of
the unit to ensure good
ventilation.
After the heater has been
switched on, wait 15-20
minutes for the heater to
reach the maximum tem-
perature.
The ideal mounting position
is directly above the area to
be heated with a longitudi-
nal orientation and directed
vertically downwards.
Insert the arch shaped
support in the special rail
on the upper side of the
device.
Align the holes of the
supports and join them
together using the supplied
bolts, setting the desired
inclination.
Tighten the safety
screws.
Provided wall/ceiling support:
The support to
be fixed
to the wall pres-
ents a series of
holes that allow
to fix the heater in different
positions.
GB