Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
ATTENTION: Before installing the
new wheel hub bearing unit, the
bearing surface in the wheel bearing
housing must be cleaned.
1
Install the mounting shells (5) to
the new wheel hub/bearing unit
with the fastening bolts for the
mounting shells (9).
2
Lay the new hub/bearing unit
onto the pressure plate (2) so
that the pressure bolts (3) touch
the mounting shells (5) through
the wheel stud holes.
3
Attach the thrust piece (6)
sideways to the drive shaft and
lead the spindle (1) with the
attached mounting plate (2) and
new hub/bearing unit from the
front through the bearing
housing and the thrust piece (6).
4
Mount the new wheel
hub/bearing unit by turning the
spindle (1) and counter holding
the spindle nut (8).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Fig.8
Fig.9
Fig.10
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
