Alignment (Adjustments); Changing The Table Bevel Angle; To Adjust 90° Table Stop And Align The Bevel Indicator - RIDGID SS1650 1 Manual Del Usuario

Alignment (Adjustments)

Changing the Table Bevel Angle

• The scroll saw work table can be tilted to
the left for bevel cutting up to 45° from
the 0° or horizontal cutting position.
• A bevel scale and indicator are provided
under the work table as a convenient ref-
erence for setting the approximate table
angle for bevel cutting.
• A 90° table stop is provided under the
table to allow the table to be tilted and
returned to an accurate 90°.
NOTE: A scroll saw is a scroll curve cut-
ting tool. It is not intended for making
precise angular cuts in wood. The indi-
cator is provided to give approximate
angular readings. A precision protractor
or square should be used to measure a
more precise blade to table angular loca-
tions.
To Adjust 90° Table Stop and Align
the Bevel Indicator
• Loosen the table bevel lock knob and
use a small square to set the table at 90°
to the blade.
• Loosen the table stop jam nut and adjust
the stop bolt in or out to accurate 90°.
• Tighten the jam nut.
• When there is no space between the
square and the blade, hold table in place
and tighten the bevel lock knob. The
table should now be approximately 90°
to the blade.
• Loosen the screw holding the bevel
scale pointer and adjust to 0°. Tighten
screw.
Remember, the bevel scale is a conve-
nient guide but should not be relied
upon for precision.
Bevel
Scale
Bevel
Pointer
11
Bevel
Lock Knob