Charger Operation - SNOWJOE iON100V-24SB-CT Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Charger Operation

TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY.
In order to operate this cordless snow blower you will
need two iON100V-5AMP or greater batteries and the
iON100V-RCH charger from the iONPRO100V System. See
page 22 for battery and charger options and specifications,
or for more information visit snowjoe.com.
m
WARNING!
Charge only the iON100V-5AMP or greater
lithium-ion battery packs in compatible iON100V-RCH battery
charger. Other types of batteries may cause personal injury
and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the iON100V-5AMP
Lithium-Ion Batteries
NOTE: The iON100V-5AMP lithium-ion battery packs do
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery packs before charging.
• Use the battery charge indicator lights to determine when to
charge your iON100V-5AMP lithium-ion battery packs.
• You can "top-off" your battery packs' charge before starting
a big job or after a long day of use.
Charging the Battery Packs
1. Flip open the battery compartment cover, push the battery
releasing buttons to release the battery packs. Pull the
batteries out of the equipment (Fig. 4).
Fig. 4
Battery compartment cover
Battery packs
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the red light will illuminate steadily
(Fig. 5).
Fig. 5
m
CAUTION!
Charger iON100V-RCH is rated for 100 –
120 volt AC only. DO NOT plug the charger into any outlet that
will provide power with a higher voltage. Over voltage charging
will be harmful to both the battery and charger, and may cause
the charger to burn out.
3. Place one of the battery packs into the charger by sliding
the pack as shown until it clicks into the position. When
the battery is inserted properly, the green light will slowly
flash to indicate that the battery is charging. The red light
will turn off. You will also hear a fan sound (Fig. 6).
4. When the green light stays on, the battery is fully charged
(Fig. 6).
Fig. 6
Slowly flash green
Charging
10
Red
Green
Fully Charged

Publicidad

Tabla de contenido
loading

Tabla de contenido