Facom BAT.TESTU Manual Original página 7

BATTERY TEST:
All manuals and user guides at all-guides.com
1. Select BATTERY TEST. Press «ENTER».
2. Press the /  to select REGULAR/STD or START/STOP battery.
REGULAR/STD
* REGULAR/STD BATTERY:
FLOODED, AGM FLAT PLATE, AGM SPIRAL, VRLA/GEL
* START/STOP BATTERY: AGM FLAT PLATE, EFB
3. Press the  /  key to select the battery type:
4. Press «ENTER» to confirm choice.
5. Press the  /  key to select the battery rating:
CCA/SAE, EN, JIS, DIN, IEC, & CA/MCA.
6. Press «ENTER» to confirm choice.
7. Press the  /  key to input the battery capacity.
CCA/SAE: 40~2000
EN: 40~1885
DIN: 25~1120
IEC: 30~1320
JIS: By Battery Type No.
CA/MCA: 50~2400
8. Press the  /  key to confirm temperature.
9. Press <<Enter>> to begin the test.
* Return Feature: Before the test is started, the user can always
return to the previous setting page by pressing <<ENTER>> for
2 seconds.
SURFACE CHARGE NOTICE:
The battery will hold a surface charge if the engine has been running
or after the battery has been charged. The tester may prompt you to
remove the surface charge.
BATTERY TEST
XX.XX V
START/STOP
BATTERY TYPE:
AGM FLAT PLATE
SELECT RATING:
CCA/SAE
SELECT
CAPACITY:
560CCA/SAE
ABOVE 32°F/0°C?
YES/NO
7