Facom BAT.TESTU Manual Original página 9

RECHARGE & RETEST
All manuals and user guides at all-guides.com
*Battery is discharged, the battery condition
cannot be determined until it is fully charged.
Recharge & retest the battery.
BAD & REPLACE
*The battery will not hold a charge. It should
be replaced immediately.
BAD CELL & REPLACE
*The battery has at least one cell short circuit.
It should be replaced immediately.
LOAD ERROR
*The tested battery is bigger
than 2000CCA/SAE or 200AH.
Or the clamps are not connected properly. Please fully charge the
battery and retest after excluding both previous reasons. If reading is
the same, the battery should be replaced immediately.
14. SOC & SOH Display: Press directional keys to see SOC & SOH:
SOC:
■■■■■■■■■❏ 90%
15. Press the  /  key to select result printing:
YES or NO. Press «ENTER» to confirm
your choice.
*24V System Test Printing: The printer will
not function for 24 Volt batteries system
test printing. The 24V system test result will
be recorded till you hook up to a 12V battery
and the right screen shows up.
Please select "YES" and press enter key to print the result and
then disconnect the clamps. The screen will appear again after you
reconnect the clamps. Please select "NO" and press the enter key
to go back to the main menu.
GOOD & PASS
xx.xx V
GOOD & PASS
CCA : xxx CCA/SAE
■■■■■■■■■❏ 90%
GOOD &
RECHARGE
VOL: xx.xx V
CCA : xxx CCA/SAE
IR: xx.xx mΩ
BAD &
REPLACE
VOL: xx.xx V
CCA : xxx CCA/SAE
IR: xx.xx mΩ
BAD CELL &
REPLACE
VOL: xx.xx V
CCA : xxx CCA/SAE
IR: xx.xx mΩ
LOAD ERROR
PRINT RESULT?
YES/NO
PRINT 24V
SYSTEM
RESULT? YES
9