Sauder East Canyon 419342 Manual De Instrucciones página 21

Step Step 17
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (J) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW a
few turns before completely tightening any of them.
Fasten a PULL (101K) to the LEFT DOOR (J). Use two
å
SILVER 3/4" MACHINE SCREWS (20S).
Repeat this step for the RIGHT DOOR (I).
å
Fasten a STRIKE PLATE (6I) to the LEFT
å
DOOR (J). Use one BLACK 1/2" FLAT
HEAD SCREW (11S).
See Step 19 for DOOR adjustments.
å
BLACK 1/2" FLAT HEAD SCREW
(1 used for the STRIKE PLATE)
www.sauder.com/services
11S
20S
SILVER 3/4" MACHINE SCREW
(4 used for the PULLS)
6I
J
101K
419342
Mounting
screw
Hinge
B
Stop
Page 21