Important - Sauder East Canyon 419342 Manual De Instrucciones

Step 3
NOTE: Do not peel the backing completely off of the FELT STRIP (84M).
å
Partially peel the paper off the back of the FELT STRIP (84M), giving yourself enough of the FELT STRIP to cover the fi rst
å
couple of inches of the BARREL REST (G).
IMPORTANT: Do not pull tightly on the FELT STRIP as you apply it to the BARREL REST. Pulling the strip tight as you apply
å
it will cause the felt to separate from the edge of the board.
Apply the FELT STRIP (84M) to the BARREL REST (G). Start the exposed end of the FELT STRIP at one end of the
å
BARREL REST and fi rmly press, do not pull, on the FELT STRIP. Work your way down the BARREL REST. Trim any excess
FELT STRIP off with your scissors.
NOTE: When pulling back the release paper on the FELT STRIP, be sure you do not pull on any of the FELT STRIP already
å
applied to the BARREL REST.
Turn six CAM SCREWS (8F) into the MOLDINGS (M and O).
å
www.sauder.com/services
G
84M
8F
(6 used)
M
419342
O
Page 7