Basic Operations - Mitsubishi Electric CITY MULTI PAR-30MAA Manual Del Usuario

Basic operations

Operation mode icons
Cool
Heat
Turning ON and selecting operation mode
1
Press button 1 ( ON/OFF ).
2
Press button 7 ( F1 ) to go through the operation
modes.
Cool Dry
*1 Operation modes that are not available to the connected indoor unit models will not appear on the display.
*2 Interlocked operation is performed in all the operation modes when the ventilation unit is interlocked.
Preset temperature setting
Press button 8 ( F2 ) to decrease the preset temperature.
Press button 9 ( F3 ) to increase the preset temperature.
* Pressing once changes the value by 1ºC (1ºF).
Operation mode Preset temperature range
Cool/Dry 19 ~ 30 ºC (67 ~ 87 ºF)
Heat 17 ~ 28 ºC (63 ~ 83 ºF)
Auto 19 ~ 28 ºC (67 ~ 83 ºF)
Fan/Ventilation Not settable
Fan speed setting
Press button 0 ( F4 ) to go through the fan speed.
* The number of available fan speeds depends on the model.
4 speeds
3 speeds
2 speeds
1 speed
Dry Fan
Auto cool
Fan Auto
*1
* The settable temperature range varies with the model of indoor units.
* The temperature range restriction setting will be applied preferentially,
if any. If the setting value is outside of the range, a message "Temp.
range locked" will appear. Refer to the Instruction Book of the remote
controller for details.
<Note>
The actual fan speed will be different from the fan speed displayed on
the LCD when one of the following conditions is met.
• While "Standby" or "Defrost" is displayed
• When the room temperature is higher than the preset temperature during
the heating mode
• Right after the heating operation (during stand by for switching the
operation mode)
• During the dry mode
No display
Auto
Auto heat
The ON/OFF lamp and the LCD will light up.
F1
Heat
*1
5