Daily use
After drying
The tumble dryer stops operation automatically when a dry cycle is complete. The display
.
shows
Notice
The last part of the drying cycle occurs without heat (cool down cycle) to ensure re-
maining the garments at a temperature which does not damage them.
27
26
28
29
30
31
32
Standby mode / power- saving mode
The switched on appliance will go into standby-mode if it will not be activated within 5 min-
utes before starting the programme or at the end of programme. This saves energy. To
interrupt the standby-mode push the "On/Off button
20
1. Press "On/Off "
ance. (fi g.: 26).
2. Remove laundry as soon as possible to go easy
on it and to prevent more wrinkling (fi g.: 27). If
the laundry is not removed the anti-crease pro-
gramme starts automatically. In anti-crease
phase, the drum will rotate 30 sec. in each 5.5
minutes, the total phase time will last for 1 hour.
3. Unplug the power cord (fi g.: 28) .
4. Empty the water tank (fi g.: 29).
5. Clean the lint filter in the fi lling opening (fi g.: 30) .
6. Clean the condenser fi lter (fi g.: 31) .
7. Open the door to prevent formation of moisture
and odours. Let it open while not used ( fi g.: 32).
button to switch off the appli-
.
EN