Haier HD90-A636-E Manual Del Usuario página 27

EN
Problem Possible cause
Drying time is • The load was too small?
too short.
• The laundry was too dry?
Creasing at the • The tumble dryer is overloaded?
laundry.
• The right programme was se-
Door does not • Laundry is clamped between
close.
Remaining time • The remaining time will be ad-
on the display
stops or skips.
The drum interi- • Appliance is connected to the
or light does not
work. • The
• The light bulb is still functional?
In case of power failure
In case of power failure, the current programme is stored only for a short time. Usually, a
restart of the programme is required.
WARNING!
Quickly remove all items and spread them out that the heat can be released.
lected?
door and gasket?
justed continuously
upon the following factors:
- Type of laundry.
- Loaded amount.
- Moisture degree of the laundry.
- Ambient temperature.
power supply?
appliance has
switched on?
Troubleshooting
Possible solution
• For single items or small
amount of laundry the TIMER
programme should be selected.
• Select the TIMER programme
or a higher dry level.
• Reduce the amount of laundry.
• Remove laundry immediately
after programme end, hang
them up and pull them into
shape.
• Select and adjust the pro-
gramme according to the fab-
ric type.
• Insert laundry correctly.
• The automatic adjustment is a
based normal operation.
• Check power supply
• Switch the machine on.
been
• Contact the customer service
to replace the lamp.
27