Troubleshooting - Haier HD90-A636-E Manual Del Usuario

EN
Many occurring problems could be solved by yourself without specifi c expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
Electrical equipment should be serviced only by qualifi ed electrical experts, because
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service
agent or similarly qualifi ed persons in order to avoid a hazard.
Information codes
Following codes are displayed only for information referring to the drying cycle. No meas-
ures must be performed.
Code Message
Automatic load detection is working.

The remaining programme time will be 1 hour and 25 minutes.
:
Delayed start of programme is activated. The start of programme cycle will
:
be in 7 hours.
The programme is fi nished. Switch off the appliance and remove the laundry.

Troubleshooting with display code
Code Cause
Filters are clogged.

 Ambient temperature is too low.
Drain pump error.

Temperature of the laundry in the drum does not change. Contact the customer service.

 Communication failure between PCB and display.

The condenser thermal sensor is open-circuited
or short -circuited.

Should the error codes reappear even after the taken measures, switch off the appliance,
disconnect the power supply and contact the customer service.
All other Alarmcodes:
1. Note Alarmcode
2. Contact Service ; refer to CUSTOMER SERVICE.

Troubleshooting

Solution
Clean fi lters.
Only use the dryer at ambient
temperatures higher than 5 °C.
Contact the customer service.
Contact the customer service.
Contact the customer service.
25