Publicidad
63
64
Q1
Q1
*Inside Enclosure*
*Dentro del recinto*
S1
Q
S1
Q
R1
Q
Risk of injury or product damage. DO NOT operate or test
Risk of injury or product damage. DO NOT operate or test
door panels at this time. ONLY test door function after
door panels at this time. ONLY test door function after
ALL components have been installed.
ALL components have been installed.
Q
Carefully close sliding glass panel (Q1).
Next, using a pencil, mark the location of the inner edge
of the strike wall jamb (S1).
Cierre cuidadosamente el panel de vidrio de corredera
(Q1).
A continuación, marque la ubicación del borde interno
de la jamba de pared de cierre (S1) con un lápiz.
2
Risk of injury or product damage. DO NOT operate or test
Risk of injury or product damage. DO NOT operate or test
door panels at this time. ONLY test door function after
door panels at this time. ONLY test door function after
ALL components have been installed.
ALL components have been installed.
Open sliding glass panel (Q1) and remove magnetic strike
seal (R1) from strike wall jamb (S1).
Abra el panel de vidrio de corredera (Q1) y extraiga la
junta de cierre magnético (R1) de la jamba de pared de
cierre (S1).
41
CAUTION
CAUTION
PRECAUCIÓN
PRECAUCIÓN
CAUTION
CAUTION
PRECAUCIÓN
PRECAUCIÓN
Publicidad
