McCulloch MT260 Manual Del Usuario página 4

GRASS TRIMMER DESCRIPTION
11
19
18
15
12
10
1. Power cable
2. Upper handgrip
3. Switch
4. Central support
handgrip
E
5. Adjustment
N
handwheel
G
6. Central tube
7. Lower body
L
8. Air slots
I
9. Guard
S
10. Nylon wire
H
ASSEMBLY
The grass-trimmer is supplied with some components
not assembled. To assemble these proceed as follows:
• ATTACH SUPPORT HANDLE (FIG. 2)
1. Insert the joint (2) into the upper body from the
lower side. Fit the handle (3) between the joint fins
(2).
2. Insert the handwheel into the hole of the joint and
tighten them to the nut.
3. Before tightening completely, adjust the support
handle height by sliding handle up and down tube.
When support handle is at desired operating
height, tighten it security.
Fig. 2
2
3
16
3
4
2
17
5
1
6
7
8
9
13
14
11. Spool carrier
12. Spool
13. Spring
14. Spool cover
15. Cutting guide
16. Security Lock
17. Height control
button
18. Rotation control
button
19. Wire-cutting blade
1
3
4
5
CAUTION: Wire-cutting blade on grass
guard is sharp, contact with it could cause
personal injury.
• ATTACH GRASS GUARD (FIG. 3)
Insert the guard (1) onto the lower body and secure it at
the rear with two screws (2). Fit the cutting guide (3) on
the front part of the guard with another two screws (4).
• USE OF THE CABLE-HOLDER (FIG. 4)
The handgrip is supplied with a system for holding the
extension cable.
CAUTION: Never use the grass trimmer
without the guard. It is vital for your and
other peoples' safety and for the good
working order of the trimmer. The failure to
observe these safety regulations could
cause dangerous.
Fig.3
1
3
2
4
STARTING
1. When starting the grass-trimmer for the first time,
check that the nylon wires touch or pass over the
wire-cutting blade. If they are not long enough,
press the button and, at the same time, pull the
nylon wires (Fig. 5).
2. Connect the plug of the grass-trimmer to the exten-
sion cable and attach this to the handle (Fig. 4)
3. Make sure the height of grass trimmer and support
handle is most applicable before use, adjust the
height of grass trimmer by pressing the height con-
trol button adjust the height of support handle by
releasing and the handwheel.
4. Take a secure hold of the grass trimmer and, with-
out letting it touch the grass to be cut unlock secu-
rity then press the switch on the upper handgrip.
Let the grass trimmer run idly for a few seconds
and then carry out the self-adjustment of the length
of the nylon wire.
5. To switch off the grass trimmer let go the switch.
Fig.5
Fig.4
Fig.6