• TRIMMING GRASS IN VERTICAL DIRECTION
(FIG. 13)
To cut the edges of the grass or of the flower beds,
transform the grass trimmer as follows:
1.
Disconnect the plug from the electric power supply.
2.
Hold the top handgrip with one hand and the lower
body with other hand.
3.
Press the rotation button on lower body and rotate
the lower body of 180˚ clockwise until blocking (1).
4.
In this way the grass trimmer is transformed into
vertical direction and you will be able to cut the
grass vertically (3).
5.
To go back to the original position, repeat the pre-
vious operations rotating anti-clockwise the lower
body.
Fig.13
E
MAINTENANCE
N
G
CAUTION: Before carrying out any
L
maintenance operations, cut off the electric
power supply by disconnecting the plug
I
from the extension cable.
S
H
1.
Regular cleaning and maintenance of your grass
trimmer will ensure efficiency and prolong the life
of your machine.
2.
After each cutting operation, take apart and clean
out the grass and soil from: the spool and its slot,
the whole trimmer and in particular the guard.
3.
During operation, keep the air slots clean and free
of grass.
4.
Only use a cloth soaked with hot water and a soft
brush to clean the grass trimmer.
5.
Do not spray or wet the appliance with water.
6.
Do not use detergents or solvents as these could
ruin the trimmer. The parts in plastic can easily be
damaged by chemical agents.
7.
If the wire cutting blade no longer cuts or breaks,
have this replaced by contacting an authorized
service centre.
CAUTION: The blade can give deep cuts.
For repairs which have not been explained
in these instructions, contact an authorized
service centre.
5