Machine Usage - Garland Roll&Comb 302 W-V20 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
5.8. START UP AND STOPPAGE
Do not place hands or feet under the
comber. Maintain all body parts well
clear from all movingelements when the
machine is in use.
After stopping the machine, the comber will not stop
inmediately. Wait until it has stopped before carrying
out any maintenance work on the machine or before
transporting the machine.

6. MACHINE USAGE

Use this machine only for those purposes for
which it has been designed. The usage of this
machine for any other purposes is dangerous and can
cause damages to the user and the machine.
Do not get anywhere near to the comber when the
machine is working.
If you lose your balance or fall, let go of the handle
switch immediately.
Do not solely rely on the security measures of this
machine. Use common sense at all times.
Do not use this machine if you are tired, sick, are
taking medicines, or if under the effect of alcohol or
drugs. Lack of sleep and fatigue can cause accidents
and damages.
Do not use this machine at night, with fog or with
reduced visibility. You must see the working area
clearly at all times.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Never leave this machine unattended.
All manuals and user guides at all-guides.com
Do not allow anybody into the working area whilst the
machine is in use. The working perimeter is minimum
15 metres and this is the danger zone.
Clean and remove obstacles from the working area
that could cause accidents prior to use.
Do not use accessories on this machine except those
recommended by the manufacturer as otherwise the
use of non recommended accessories could cause
severe damages to the user and to the machine.
6.1. HOLDING AND GUIDING THE MACHINE
While working always hold the machine firmly with
your hand on the handle.
Attention! The machine can jump up or forwards
inadvertently, if the comber hit something hard that is
underground such as big stones, roots or trunks or if
the ground is too hard or if it is frozen. Always hold the
machine firmly with both hands.
Attention! Always keep an eye as to where the
electric cable is whilst working. Be careful and
ensure that your feet or any object get tangled with
the cable.
6.2. ADJUSTING THE WORKING HEIGHT
Attention! Stop the machine and wait for
the comber to stop before adjusting the height
adjustment. The comber need a few moments to stop
completely after stopping the engine.
To adjust the height, raise the front of the machine,
move the adjusting thread (8) to the desired height
and lower the machine again.
28/84

Publicidad

Tabla de contenido
loading

Tabla de contenido