Simpson 3600 PSI Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect Spray
4
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
Release Air from
7
System
Release all
air from pump and
high pressure hose by
depressing trigger until a
steady stream of water is
present. Approximately
30 seconds.
30 S
Move the Choke
10
to the CLOSED
Position
See label #10 on unit.
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the Fuel
8
Switch is in the
ON Position
See label #8 on unit.
Pull the Recoil
11
Starter Grip
Pull the
recoil starter grip to
start the engine.
See label #11 on unit.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Engine
9
Switch is turned
to the ON
Position
See label #9 on unit.
Move the Choke
12
to the OPEN
Position
Gradually move
the Choke to the
OPEN Position after
engine starts.
See label #12 on unit.

Publicidad

Tabla de contenido
loading

Tabla de contenido