Quick Connect Nozzles - Simpson MSH3224 Manual De Instrucciones

J. Pump Inlet
k. Quick Connect Nozzles
L. Nozzle holder
M. Top handle
BASIC ELEMENTS OF AN ENGINE
Refer to the Engine Owner's Manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. Slide the handle assembly (G) onto the frame (H).
NOTICE: Risk of personal injury. Avoid placing hands between handle and frame
when assembling to prevent pinching.
4. Align holes in the top handle (M) with the mounting holes in the handle
assembly (G).
5. Insert saddle bolts (DD) through aligned holes and secure top handle to handle
assembly with knobs (EE). Tighten until snug.
2
G
h
6. Remove colored quick connect nozzles (K) from plastic bag and insert them
into correct grommet on the nozzle holder (L). NOTE: Nozzles are color coded
to match colored nozzles on panel.
7. Connect wand (E) to gun (D). Tighten securely.
8. Attach high pressure hose (C) to gun (D). Tighten se cure ly.
D
NOTICE: The engine is shipped without oil. Before starting engine, add the oil
provided. Damage to the engine will occur if the engine is run without oil, this
damage will not be covered under warranty.
ASSEMBLY INSTRUCTIONS (FIG. 2–4)
G
EE
3
M
DD
4
E
11 - ENG
k
2A
L
D
C
k
L