Assembly; Attach Handle; Carton Contents - Briggs & Stratton PRO3400 Manual Del Propietário

ASSEMBLY

IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
• Remove the parts bag packed with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
• Roll pressure washer out of carton.

Carton Contents

Items in the carton include:
• Main Unit
• Safety Goggles
• Handle
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Oil Bottles (2)
• Parts Bag (which includes the following):
• Owner's Manual
• Engine Manual
• Owner's Registration Card
• Bag containing 5 multi–colored Quick Connect Spray
Tips
• Maintenance Kit
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115.
3400 PSI Pressure Washer
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle to main unit.
3. Remove shipping cap and install dipstick in pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect spray tip to nozzle extension.

Attach Handle

1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2. Insert carriage bolts through holes from outside of unit
and attach plastic knob from inside of unit (Figure 2).
Tighten by hand.
Figure 2 — Secure Handle
3. Insert multi–colored nozzles in spaces provided in
handle.
6
6
Handle
Handle
Supports