Add Engine Oil And Fuel - Briggs & Stratton PRO3400 Manual Del Propietário

Install Oil Dipstick on Pump
To install the oil dipstick:
1. Make sure unit is on a level surface.
CAUTION
You MUST remove the pump's shipping cap and install
the oil dipstick.
• Failure to do so will void the warranty and damage the
pump.
2. Remove and discard shipping cap located on pump
(Figure 3).
Figure 3 — Install Oil Dipstick onto the Pump
Remove shipping cap and
install oil dipstick here.
Pump Oil
Dipstick
3. Install oil dipstick (may also be called vent cap).
3400 PSI Pressure Washer

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
NOTE: Check oil often during engine break–in. Refer to
engine owner's manual for recommendations.
Shipping Cap
7
7
CAUTION
instruction will void warranty.