Broan ALLURE QS2 Serie Instrucciones página 4

PREPARE THE HOOD
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
Remove appropriate Duct Knockout(s) from top or back of
11
hood.
TIES
SCREW
METAL STRIP
PLATE
12 Horizontal Discharge Only: Remove the Plate in front of the
horizontal discharge knockout. Cut the Ties, lift plate out, and
discard plate. DO NOT REMOVE the Metal Strip held in place
with two Screws.
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
PREPARE THE HOOD
UP TO 1"
SIDE-TO-SIDE
ADJUSTMENT
PIVOT
13 3¼" x 10" Ducted Discharge Only: Remove Tape from damper
flap and attach Damper/Duct Connector over knockout
opening with screws removed in Step 4 under "PREPARE
THE HOOD" . Make sure damper Pivot is nearest to Top/Back
Edge of hood.
7" Round Ducted Discharge Only: Re-install 7" Round Duct
14
Plate removed in Step #1 under "PREPARE THE HOOD" .
Install a 7" round damper (purchase separately). Damper
flap must open freely in direction of airflow (away from range
hood).
To accomodate off-center ductwork, the Damper/Duct
NOTE
Connector can be installed up to 1-inch on either side of
hood center or the 7" Round Duct Plate can be installed
up to ½" on either side of hood center. In extreme off-center
installations, one end of the duct connector may need to be trimmed
to clear the electrical cable clamp.
BLOWER
RETAINING
WHEEL
RING
SECTIONS
MOTOR
SLOTS
15 Non-Ducted Installations Only: Require a Performance Ring
to be attached to the blower wheel.
To install ring:
1. Remove the Blower Wheel by rocking it side to side and
applying a slight force to pull wheel from motor. Remove
Retaining Ring if necessary.
2. Slide the ring onto the Small Diameter End of the wheel
and down to the Stop Edge of the wheel.
3. Reassemble wheel to motor. Make sure Tab on wheel fits
into one of the Motor Slots.
4. Push wheel down until it is locked in place.
5. Check that wheel is properly positioned as shown. Press
Sections into place if necessary. Make sure wheel turns
freely.
ALLURE QS2 SERIES
®
RANGE HOOD
TOP/BACK
TAPE
CONNECTOR
(Vertical discharge
position shown)
TAB
SMALL DIAMETER
END
RING
STOP
EDGE
Page 4
EDGE
DAMPER/
DUCT