Connections, Controls And Indicators - Cameo CLSB83 Manual De Usuario

CONNECTIONS, CONTROLS AND INDICATORS:

FRONT PANEL
1 2
2
DMX THRU
Model CLSB83: Female 3-pin XLR jack to route the DMX signal from the DMX input (DMX IN) on to another
DMX splitter/booster.
Model CLSB85: Female 5-pin XLR jack to route the DMX signal from the DMX input (DMX IN) on to another
DMX splitter/booster.
Important Notice: The signal lines of the DMX THRU sockets on the front and back are parallel (no splitter
function). To avoid malfunctions, use exclusively either the DMX THRU socket on the front panel, or the DMX
THRU socket on the rear panel to forward the DMX signal.
3
POWER LEDS CHANNEL 1 - 8
The LEDs of the upper LED row display the power supply of the channels 1 to 8.
4
SIGNAL LEDS CHANNEL 1 - 8
The LEDs of the lower LED row display if a DMX signal is present at the DMX output 1 to 8.
5
TERMINATOR
Switchable 120 ohm terminating resistor for the DMX THRU output jack. To avoid malfunctions, activate the
terminating resistor only in the last device in a chain of splitter/booster by ensuring that the TERMINATOR
switch is pressed. Activate the terminator also, if only one splitter/booster is used in a DMX-system.
6
POWER ON/OFF
On / Off switch for the power supply of the device.
1
DMX IN
Model CLSB83: DMX input with male 3-pin XLR jack for connection
of a DMX controller.
Model CLSB85: DMX input with male 5-pin XLR jack for connection
of a DMX controller.
Important Notice: The signal lines of the DMX inputs on front and
back (no merge function) are parallel. To avoid malfunctions in DMX
devices (LED projectors, moving heads, etc.), use exclusively either
the DMX input on the front, or the DMX input on the rear panel to
connect a DMX control unit.
3
4
6
5
7