Cameo CLSB83 Manual De Usuario página 8

CONNECTIONS, CONTROLS AND INDICATORS:
BACK PANEL (CLSB83 shown)
1
IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
1
Used to power the device. An appropriate power cord is included in the delivery.
IMPORTANT INFORMATION: BEFORE using this equipment, make certain that the mains voltage of your
energy supplier and the operating voltage of the device match! Replace the fuse only with a fuse of the same
type and rating (see label on the rear panel)!
If the fuse blows repeatedly, please contact an authorised service centre.
OUT 1 - OUT 8
2
Model CLSB83: DMX output with female 3-pin XLR jack for connecting a DMX device, or multiple DMX
devices in a chain (up to 32 units). For the last DMX device (projector, moving head, etc.) in a DMX chain,
always use a terminator (terminating resistor).
Model CLSB85: DMX output with female 5-pin XLR jack for connecting a DMX device, or multiple DMX
devices in a chain (up to 32 units). For the last DMX device (projector, Moving Head, etc.) in a DMX chain,
always use a terminator (terminating resistor).
DMX THRU
3
Model CLSB83: Female 3-pin XLR jack to route the DMX signal from the DMX input (DMX IN) on to another
DMX splitter/booster.
Model CLSB85: Female 5-pin XLR jack to route the DMX signal from the DMX input (DMX IN) on to another
DMX splitter/booster.
Important Notice: The signal lines of the DMX THRU sockets on the front and back are parallel (no splitter
function). To avoid malfunctions, use exclusively either the DMX THRU socket on the front panel, or the DMX
THRU jack on the rear panel to forward the DMX signal.
4 DMX IN
Model CLSB83: DMX input with male 3-pin XLR jack for connection of a DMX controller.
Model CLSB85: DMX input with male 5-pin XLR jack for connection of a DMX controller.
Important Notice: The signal lines of the DMX inputs on front and back (no merge function) are parallel. To
avoid malfunctions in DMX devices (LED lights, moving heads, etc.), use exclusively either the DMX input on
the front, or the DMX input on the rear panel to connect a DMX control unit.
8
2 2 3 4