Special Safety Instructions - Rothenberger ROMAX 3000 Instrucciones De Uso

d) Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
6) Service
Have your power tool serviced by a qualified repair person using only identical re-
placement parts. This will ensure that the safety of the power tool is maintained.
1.3

Special safety instructions

The term press jaw also includes main Jaw, press ring and press chain.
ROMAX 3000:
Never hold your fingers or other body parts in the working area of the cylinder or the press jaws.
Remove the battery before carrying out any work on the machine.
If the device is so badly damaged that electric cables or drive parts are exposed, disconnect the
mains plug immediately and contact your service outlet. Unauthorised repair work may result in
the user suffering major injuries or even death.
Only personnel trained in how to use the device may make crimp pipe joints using the ROMAX
3000.
The machine may only be used with a press jaw inserted into it. The press jaw must be in per-
fect technical condition.
Only start the machine if it is in perfect working order.
Servicing and repair work may only be carried out by workshops authorised by ROTHEN-
BERGER.
Use only suitable press jaws and press fitting systems that have been approved by ROTHEN-
BERGER.
After you have inserted the press jaw check that the bolt is securely locked.
In the event of problems during the pressing process, press the EMERGENCY STOP button.
Check that the pipe joint is secure after you have completed the pressing process.
Imperfect pipe joints must be compressed again using a new fitting.
Follow the installation instructions supplied by the fitting and pipe manufacturers.
Assure by pressing leaky press fittings that no humidity respectivily lotic water reaches into the
inside of the machine!
After finishing the work, check the installation with appropriate testing equipment and assure that
it is leakproof!
Battery / Charger:
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been giv-
en supervision or instruction concerning use of this product by a person responsible for their
safety. Children should be supervised to ensure that they do not play with this product.
RISK OF EXPLOSION!
Physical injury!!
The battery charger may not be used to charge other batteries or rechargeable batteries.
Ventilation slots of the battery charger must not be covered up.
Please pay attention to the following symbol on the label of the charger:
This tool is only suitable for indoor use. Never expose tool to rain!
No metal parts are allowed to enter the battery section of the charger (risk of short circuit).
Do not charge battery in direct sunlight. Only use the battery in an ambient temperature be-
tween -10°C and 50°C / 14°F and 50°F.
14
RISK OF FIRE! Short-circuit! Do not bridge contacts of the battery
charger with metal parts!
ENGLISH