Components; Warnings - Sagola HT10 Manual De Instrucciones

1 Suction Probe (Fig. 2)
2 Product return hose
3 Product return key
4 Pressure Regulator (Unit)
5 Pressure Regulator (Gun)
6 Product Outlet
7 Pressure Gauge (Unit)
8 Pressure Gauge (Gun)
9 Air inlet
10 Product inlet
11 Wall support (OPTIONAL) (Fig.3)
FIG. 3
- Before putting the unit into operation, and especially after
each cleaning and/or repair operation, a check must be made
that the equipment components are securely tightened and
that the hoses are airtight (no leaks). Faulty parts must be
replaced or repaired as appropriate.
- The Unit is easy to handle thanks to its design and the
simplicity of its mechanisms. No special training is required
for handling the unit. Use it according to the operating,
maintenance and safety instructions indicated in this manual
and follow the application methods indicated to obtain the
required quality of finish.
· Before putting the unit into operation, we recommend that
you clean the equipment as this has been subjected to
functional tests and before packaging it is treated internally
with a protective coating, some of which may still remain.
Apply thinner to eliminate this. Remove any residual grease
applied during assembly.
- The unit is depressurised when supplied (no pressure
inside).
- Ensure that the products to be applied are chemically
compatible with the components these come into contact
with (aluminium, stainless steel, polythene and acetylene
resin).
- Do not use corrosive or abrasive products.
- Use SAGOLA anti-static hoses suited to the product to be
transferred.

4. COMPONENTS

FIG. 1
6
3
11

5. WARNINGS

5
9
2
- You must always connect the equipment and all the
elements involved in the work process to a grounding
connection to eliminate static electricity. Regularly verify (one
a week) its electrical continuity. If its resistance exceeds the
recommended limits, it must be fixed. An equipment unit
without or with a faulty grounding connection may make the
installation dangerous.
- The total derivative resistance must be <100 million ohms.
The unit has been designed for long service and can be
used with most products available on the market. Its use
with highly aggressive products will quickly increase the
need for maintenance and spare parts. If you need to apply
special products, please contact SAGOLA S.A.
- Read and apply all the information, instructions and safety
measures indicated by the manufacturer of the products to
be applied (products to be applied, thinners, etc.) as these
may provoke chemical reactions, fires and/or explosions, or
be toxic, irritant or harmful and in all cases dangerous for
the health and personal safety of the user and of other
persons nearby (see chapter on Safety and Health).
- Mix, prepare and filter the product to be applied in
accordance with the manufacturer's instructions, ensuring
that any foreign bodies are prevented from spoiling the quality
of finish and application. Should there be any doubt related
to the purity of the product, its composition, etc. please
contact your supplier.
Control the viscosity of the product to be applied with the
SAGOLA Viscosimeter kit- Code 564 180 01
- 17 -
10
FIG. 2
4
7
8
1