JVC KD-T801BT Manual De Instrucciones página 28

AUDIO SETTINGS
Speaker output settings
[SPK/PRE OUT]
(Applicable only if [X ' OVER TYPE ] is set to [2-WAY]) (page 21)
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier. (Page 35)
KD-T801BT:
Setting on
[SPK/PRE OUT]
[REAR/REAR] Front speakers output
[REAR/SUB.W] (default) Front speakers output
[SUB.W/SUB.W] Front speakers output
KD-T709BT/KD-T706BT/KD-T702BT:
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] (default) Subwoofer output
[SUB.W/SUB.W] Subwoofer output
22
ENGLISH
Audio signal through lineout terminal
FRONT REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
Audio signal through lineout terminal
REAR/SW
Connection via speaker leads
You can also connect the speakers without using an external amplifier
but still being able to enjoy the subwoofer output with these settings.
(Page 35)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] Rear speakers output
[SUB.W/SUB.W] Subwoofer output
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not available.
(Page 24)
– [POSITION R02] is selected in [FADER] and selectable range is [POSITION R15] to
[POSITION 00]. (Page 21)
Crossover settings
Below are the available setting items for 2-way crossover and 3-way
crossover.
Caution
Select a crossover type according to how the speakers are connected.
(Page 35)
If you select a wrong type:
• The speakers may be damaged.
• The output sound level may be extremely high or low.
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
Rear speakers output
(Mute)