Bluetooth - JVC KD-T801BT Manual De Instrucciones

BLUETOOTH®
Depending on the operating system and the
firmware version of your mobile phone, Bluetooth
features may not work with this unit.
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone (supplied)
Microphone input jack
Adjust the microphone
Secure using cord clamps (not
angle
supplied) if necessary.
12
ENGLISH
Pair and connect a Bluetooth device for the first time
1 Press source button to turn on the unit.
2 Search and select the name of your receiver ("KD-T8
device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3
Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) KD-T801BT/KD-T709BT:
"Device Name" "XXXXXX"
KD-T706BT/KD-T702BT:
"Device Name" "XXXXXX"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the following to confirm the passkey.
KD-T801BT/KD-T709BT: * ENTER
KD-T706BT/KD-T702BT: Volume knob
Operate the Bluetooth device to confirm the passkey.
(B) KD-T801BT/KD-T709BT:
"Device Name" "ENTER – YES"
KD-T706BT/KD-T702BT:
"Device Name" "VOL – YES"
Press the following to start pairing.
KD-T801BT/KD-T709BT: * ENTER
KD-T706BT/KD-T702BT: Volume knob
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. (Page 17)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed and "O" will light up when the Bluetooth
connection is established. For KD-T801BT/KD-T709BT, the battery and signal strength of the
connected Bluetooth device is shown (see [FORMAT] on page 26).
BT"/"KD-T7
"ENTER – YES" "BACK – NO"
"VOL – YES" "BACK – NO"
"BACK – NO"
"BACK – NO"
BT") on the Bluetooth