JVC KD-T801BT Manual De Instrucciones página 41

INSTALLATION/CONNECTION
Wiring connection
KD-T801BT
Connecting the ISO connectors on some VW/
Audi or Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
If your car does not have an ISO terminal
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult your
car audio dealer.
Front output/
3-way crossover: Mid range output
Rear/subwoofer output/
3-way crossover: Woofer output
Microphone input jack (Page 12)
Fuse (10 A)
Yellow (Battery wire)
Red (Ignition wire)
Ignition wire
(Red)
Unit
Battery wire
Red (A7)
(Yellow)
Yellow (A4)
KD-T709BT/KD-T706BT/KD-T702BT
Rear/subwoofer output/
3-way crossover: Woofer output
Light blue/yellow
(Steering remote
control wire)
Pin
A4 Yellow
A5 Blue/White
A6 Orange/white
A7 Red
A8 Black
B1 Purple ]
B2 Purple/black [
B3 Gray ]
B4 Gray/black [
B5 White ]
B6 White/black [
B7 Green ]
B8 Green/black [
ISO connectors * You can also connect a subwoofer speaker directly without an external subwoofer
amplifier. For setting, see page 22.
When connecting to an external amplifier, connect
its ground wire to the car's chassis to avoid
damaging the unit.
Antenna terminal
To the steering wheel remote control adapter
Color and function
: Battery
: Power control (12 V 350 mA)
: Car light control switch
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
For 3-way crossover: Tweeter (right)
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
: Front speaker (left)
For 3-way crossover: Mid range speaker (left)
: Rear speaker (left)*
For 3-way crossover: Tweeter (left)
ENGLISH
35