General Operation - Apex Pro-CARE 4 Manual De Uso

English
4. OPERATION
NOTE: Always read the operating instruction before use.

4.1 General operation

1. Switch on the main power switch found on the
side of the pump.
2. Once the pump begins delivering air into the
mattress it will take approximately 30 minutes to
fully inflate the mattress.
3. Every time when mattress is first setup for use, It
will be forced to execute Maxfirm for the quickest
inflation. The low-pressure indicator (yellow LED)
will light up when the mattress is not fully inflated
at initial inflation. If the appropriate pressure is
reached, the low-pressure indicator (yellow LED)
will go off.
4. When the initial inflation (Maxfirm process) is
completed, the system will automatically enter the
preset pressure and mode.
5. According to the weight and height of the patient,
adjust the pressure
comfortable level without bottoming out, then the
pressure in mattress will slowly increase to the
intended value after the air mattress is ready to
use.
NOTE: Every time the mattress is set up for
use, it is recommended that the
pressure first to be set to the max.
The user / career can then adjust
air mattress weight levels to the
desired softness after set up has
been completed.
10
setting to the most