Apex Pro-CARE 4 Manual De Uso página 13

English
4.2 Emergency CPR Operations
5. CLEANING
It is important to follow the cleaning procedures to avoid cross contamination. Be sure to clean the
surface in a dry and dust free environment.
CAUTION- Do not immerse or soak pump unit in liquids.
Wipe-down the mattress unit with a damp cloth pre-soaked with warm water (not to exceed 95 ℃)
containing a mild detergent, or chlorine bleach followed by an approved intermediate level
disinfectant. After cleaning, all parts should be air dried thoroughly before use.
CAUTION- After cleaning, dry the mattress without direct exposure of sunlight.
Avoid dust and proximity to dusty areas. The cover may also be cleaned using sodium
hypochlorite diluted in water. All components should be air dried thoroughly before use.
The carrying bag (if available) should be turned inside out and completely wiped down using the
disinfectant solutions. Allow it to air-dry thoroughly. Once the inside is dry, turn it back and wipe
down the outside of the bag with disinfectant solutions.
Cover Material:

Stretch

Silver
6. STORAGE
1. Lay the mattress out flat and upsides down.
2. Roll-up the mattress from the head end towards the foot end with CPR valve open.
3. Foot-end strap can then be stretched around the rolled mattress to prevent unrolling.
NOTE- Do not fold, crease or stack the mattresses.
When there is an emergency to perform CPR on the
patient, quickly pull the CPR valves to release air from
mattress. The CPR valves are located at the
head-end, right-hand-side of the mattress. The quick
connector on the pump unit can be disconnected for
even faster deflation.
+
Stretch
11