> Before Start
> Part Names
"Searching..." is displayed, the display switches to show
the SSID settings.
0 To redo the initial settings, press SETUP on the remote
controller, and set "5. Network" - "Wi-Fi" to "On". Select
"Wi-Fi Setup" after this.
Setting
From the list of SSID for access points such as wireless
LAN routers, select the required SSID and make the
settings.
1. Select the SSID of the access point you want to connect
with Up/Down on the remote controller and press
ENTER.
My SSID
2. Select "Enter Password" or "Push Button" with Up/Down
on the remote controller and press ENTER. If the access
point has an automatic connection button, by selecting
"Push Button" you can connect without entering a
password.
Enter Password
Push Button
3. If you select "Enter Password", enter the password of the
access point. For details on how to enter text, refer to
"Entering text" (P14).
If you select "Push Button", then after pressing and
holding the automatic setting button on the access point
for the required amount of time, press ENTER on the
remote controller.
4. After "Now Connecting" is displayed, the information of
the display switches when the Wi-Fi settings are
complete.
> Install
> Initial Setup
0 If "Retry" appears on the display, press ENTER to
retry the settings.
When the access point is not displayed
Press the Right button on the remote controller to select
"Other...", then press ENTER. Set by entering the SSID of
the access point you want to connect.
1. Enter the SSID. For details on how to enter text, refer to
"Entering text" (P14).
2. Select the authentication method with Up/Down on the
remote controller and press ENTER.
Security : None
Security : WEP
Security : WPA
Security : WPA2
0 If you select "None", proceed to step 3. If you select
"WEP", "WPA", or "WPA2", enter the password and
confirm.
3. After "Now Connecting" is displayed, the information of
the display switches when the Wi-Fi settings are
complete.
0 If "Retry" appears on the display, press ENTER to
retry the settings.
> Playback
Supplementary information | Advanced Setup | Others
En
13