Adjusting The Lcd Panel Angle; Inserting/Ejecting/Connecting Media; On First-Time Startup - Pioneer AVH-X7850BT Manual De Instrucciones

Basic operation

Adjusting the LCD panel angle

Important
 If you can hear the LCD panel knocking against your
vehicle's console or dashboard, touch the flip down
temporarily key from the flap menu to temporarily level
the LCD panel.

When adjusting the LCD panel angle, be sure to adjust
from the flap menu. Forcibly adjusting the LCD panel by
hand may damage it.
1 Press and hold OPEN/CLOSE to display the flap
menu.
2 Touch the tilt down key or tilt up key to adjust
the LCD panel to an easily viewable angle.
Laying the panel down.
Returning the panel to the upright position.
 As the set angle is saved, the LCD panel will
automatically be adjusted to the same position
the next time the LCD panel is opened.
Inserting/ejecting/connecting
media
CAUTION
Do not insert anything other than a disc into the disc-loading
slot.
Inserting and ejecting a disc
Inserting a disc
1 Insert a disc into the disc-loading slot.
Ejecting a disc
1 Press button to eject a disc.
Plugging and unplugging a USB stor-
age device
p This product may not achieve optimum performance with
some USB storage devices.
p Connection via a USB hub is not possible.
p A USB cable is required for connection.
1 Pull out the plug from the USB port of the USB
cable.
2 Plug a USB storage device into the USB cable.
1
2
1 USB cable
2 USB storage device
Check that no data is being accessed before pulling out the
USB storage device.

On first-time startup

1 Start the engine to boot up the system.
The "Select Program Language" screen appears.
p From the second time on, the screen shown will differ
depending on the previous conditions.
2 Touch the language.
3 Touch .
The "Location Setting" screen appears.
4 Touch the item to select the using location.
5 Touch .
The "Speaker Mode Settings" screen appears.
6 Touch the speaker modes.

Standard Mode
4-speaker system with front and rear speakers, or a
6-speaker system with front and rear speakers and
subwoofers.
 Network Mode
3-way system with a high range speaker, middle range
speaker and subwoofer (low range speaker) for reproduction
of high, middle and low frequencies (bands).
WARNING
Do not use the unit in standard mode when a speaker system
for 3-way network mode is connected to this unit. This may
cause damage to the speakers.
7 Touch [OK].
The "Smartphone Setup" screen appears.
8 Touch the item.
 Refer to Information on the connections and functions for
each device on page 19
9 Touch .
The top menu screen appears.
p Once the speaker mode is set, the setting cannot be
changed unless this product is restored to the default
settings. Restore the default settings to change the speaker
mode setting.
 Refer to Restoring the default settings on page 50
9