Install Appliance; Mount To Cabinet; Testing Operation - Bosch 800 Serie Manual Del Usuario

Three-wire Connection
Grounded Neutral

Install Appliance

Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical connections.

Mount to Cabinet

Fully insert the appliance and center it. Do not kink the
1.
electrical cable.
Screw the appliance into place.
2.

Testing Operation

Turn on power at the breaker.
1.
For Model HMC80252UC and HMCP0252UC: Check
2.
power at junction box using a volt meter.
For 240 V installation, the reading between the red
and black wires (line to line) should be 220 to
240 volts.
For 208 V installation, the reading between the red
and black wires (line to line) should be 190 to
208 volts.
For all models: Test the oven mode.
3.
Select the CONVECTION mode. See the Use and Care
Manual for detailed operation instructions.
Verify that the oven light comes on and the oven
4.
begins to preheat.
Connect red wire from oven to red wire in junction box.
▯
Connect black wire from oven to black wire in junction
▯
box.
Connect both green ground wire and white wire from
▯
oven to white, green or bare neutral wire in junction
box.
The conduit cable, where connected at the oven, swivels.
Rotate conduit cable upward (or downward) and direct
through hole prepared in cabinet to attach to junction
box.
To maintain serviceability, the flex conduit must not be
shortened and should be routed to permit temporary
removal of the oven.
Test the microwave:
5.
Place a cup of water into the oven cavity. Follow the
instructions in the Use and Care Manual on how to
heat a beverage.
Verify that the oven light comes on and the water is
6.
heated.
If any of the tests do not result as explained above,
7.
contact Service for assistance. Otherwise, the
installation is complete at this time.
9