Yamaha YSP-900 Manual De Instrucciones página 44

ENJOYING SURROUND SOUND
Decoder indicators
Depending on the input source and the selected surround
mode, the indicators in the front panel display light up as
follows:
Status
When PCM signals are being
input
When DTS digital signals are
being input or when DTS Neo:6
is selected
When Dolby Digital signals are
being input
When Dolby Pro Logic is
selected
When Dolby Pro Logic II is
selected
y
• You can select an input mode (AUTO, DTS or ANALOG) by
pressing INPUTMODE on the remote control repeatedly (see
page 71).
• Discs encoded in DTS-ES or Dolby Digital 5.1 EX will be
played back in DTS or Dolby Digital.
42
En
Indicator Dolby Pro Logic
Dolby Pro Logic II
PCM
DTS Neo:6
Notes
• Surround modes are available when the beam mode is set to a
setting other than the stereo playback or the my beam as the
DIGITAL
beam mode.
• When you select an input source (see page 37), the surround
mode used for the previously selected input source is selected.
PL
• If the power of this unit is turned off and on again, the surround
mode used for the previously selected input source before the
power was turned off is selected.
• The surround modes are available only when the CINEMA DSP
PL
programs are turned off (see page 51) or when the movie
program is selected as the CINEMA DSP program (see
page 50).
• Only Dolby Pro Logic, Dolby Pro Logic II Movie and DTS
Neo:6 Cinema are available when the movie program is selected
as the CINEMA DSP program (see page 50).
• If the surround modes are not available, "Prohibit" appears in
the front panel display when you press SURROUND on the
remote control.
• The surround modes are available only when 2-channel signals
are being input. If you try to switch between the surround
modes when 5.1 channel signals are being input, "Prohibit"
appears in the front panel display.
Surround modes and recommended
sources
Surround mode
–
Movie
Music
Game
Cinema
Music
Recommended
source
All sources
Movies
Music
Games
Movies
Music