Connections, Control And Display Elements - Cameo OPUS SP5 FC Manual De Usuario

PROPERTIES
300 W RGBAL LED. Animation wheel. Framing blades. Gobo wheel 1 with 6 rotating gobos + open, gobo wheel 2 with 7 fixed gobos + open
(gobos are exchangeable). 2 rotating prisms. Focusing and zoom function via DMX. Frost filter and iris. Multifunctional strobe. Pan and
tilt motors with 16-bit resolution. Battery-powered display for configuration when not connected to power. Automatic position correction.
Temperature-controlled fans. 3- and 5-pin DMX connectors. RJ45 network connectors. Wireless DMX™. Neutrik powerCON TRUE1 mains
connector, IN and OUT. 2 omega mounting brackets included. Operating voltage: 100–240 V AC. Power consumption 500 W.
The spotlight complies with the RDM standard (Remote Device Management). Remote device management allows the user to view the
status and configuration of RDM terminals via an RDM-capable controller.

CONNECTIONS, CONTROL AND DISPLAY ELEMENTS

8
3
1 POWER IN
Neutrik powerCON TRUE1 mains input socket. Operating voltage: 100–240 V AC / 50–60 Hz. A suitable power cable with powerCON TRUE1
plug is included in delivery.
2 POWER OUT
Neutrik powerCON TRUE1 mains output socket. Provides power to additional CAMEO spotlights. Ensure that the total power consumption of
all devices connected to the device does not exceed the given ampere (A) value.
FUSE
3
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT NOTE: Exclusively replace the fuse with a fuse of the same type and values. If a fuse
trips repeatedly, please contact an authorized service center.
DMX IN
4
Male 3- and 5-pin XLR connectors to connect a DMX control device (e.g., DMX console).
5 DMX OUT
Female 3- and 5-pin XLR connectors to transmit the DMX control signal.
6 NET IN
RJ45 network connector to connect with an Art-Net or sACN network. Use CAT-5e, or later, cables to set up the network.
NET OUT
7
RJ45 network connector to connect additional Art-Net-capable or sACN-capable devices to the network. Use CAT-5e, or later, cables to set
up the network.
8 ANTENNA FOR W-DMX™
The antenna for W-DMX™ control remains in its holder during operation (= operating position).
2
1
6
4
7
5
5