Adjusting The Nailing Depth - Makita GN900 Manual De Instrucciones

Inserting the fuel cell
Push up and pull the fuel cover to open.
► 1. Jet nozzle
Insert the fuel cell directing the jet nozzle of the meter-
ing valve toward the adaptor.
Insert the jet nozzle into the small hole of the adapter
properly.
Put the fuel cover over the metering valve and push it
down to latch.

Adjusting the nailing depth

CAUTION:
• Remove the fuel cell, the battery cartridge and
nails before adjusting the depth of nailing.
1
► 1. Screws
With the hex wrench, loosen two screws and move the
contact element.
Retighten screws firmly.
Indication lamp
Color of the indication lamp means the followings.
Blinking green: Normal status
Blinking red: Need to recharge the battery cartridge
Lighting-up-red: Recharge the battery cartridge.
Nailing cannot be performed due to no remaining bat-
tery capacity.
Blinking orange: Thoroughly cleaning is recom-
mended. Refer to the section "MAINTENANCE" to
clean inside of the tool thoroughly. To reset the orange
blinking of the indicator lamp, push the contact element
for five seconds, and then push the contact element
five times.
Blinking orange after blinking green and red alter-
nately: Fault detection is running. Remove and reinsert
the battery cartridge to reset. If fault detection is running
again, it is malfunction condition. Ask your local Makita
service center to repair it.
7 ENGLISH
1