Makita GN900 Manual De Instrucciones página 9

OPERATION
WARNING:
• Do not touch around the exhaust vent. The
surface will be so hot during or after an oper-
ation. Touching around the exhaust vent may
cause burns or injuries.
CAUTION:
• Make sure all safety systems are in working
order before operation.
1. To drive a nail, place the contact element against
the workpiece.
The fan motor is activated, fuel gas is injected into com-
bustion chamber and mixed with air by the fan.
► 1. Trigger
2. Hold the contact element pressing firmly and pull
the trigger.
Fuel gas is combusted and the nail is driven.
3. Further driving can be initiated only after both the
contact element and the trigger are released.
Anti dry fire mechanism
This is the mechanism that the tool prevents to be fired
without nail.
Dry fire prevention automatically sets up when the rest
of nails get to last 4-7 pieces.
Jammed nailer
CAUTION:
• Always be sure to remove the fuel cell and the
battery cartridge before clearing a jam.
When the nailer gets jammed, do as follows.
1. Remove the fuel cell, the battery cartridge and
nails.
► 1. Screws
2. Loosen the (2) magazine mounting screws with
the hex wrench.
1
3. Pull the handle/magazine away from the nose of
the tool and clear jam.
4. Realign the handle/magazine to the nose and
tighten mounting screws.
5. Reload a strip of nails.
WARNING:
• Make sure that the magazine mounting
screws are tight and the magazine is tight
to the nose. Attempting to fire tool with a loose
magazine will result in loss of nail control, dam-
age to the tool or nail discharge toward operator.
9 ENGLISH
1