Video Settings - Pioneer MVH-Z5050BT Manual De Instrucciones

The following speakers can be adjusted:
[Standard Mode]: Front, Rear, Subwoofer.
[Network Mode]: High, Mid, Subwoofer.
NOTE
[Subwoofer Settings] is available only when [Subwoofer] is [On].
1
Press .
2
Touch then .
3
Touch [Crossover] or [Subwoofer Settings].
4
Touch or to switch the speaker.
5
Drag the graph line to set the cutoff position.
6
Drag the lowest point of the graph to set the cutoff slope.
The following items can also be set.
Switches the subwoofer phase between normal and reverse position.
Switches the LPF/HPF setting to [On] or [Off]. When it is turned off, the high-pass
LPF/HPF
filter or low-pass filter of each speaker can also be turned on by touching the
graph lines.

Video settings

The menu items vary according to the source.
[Time Per Photo Slide]
Menu Item Description
[Time Per Photo Slide] Select the interval of image file slideshows on this product.
[5sec] [10sec] [15sec]
[Manual]
[Video Signal Setting]
Menu Item Description
[AV] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to an AV equipment.
M] [PAL-N] [SECAM]
Menu Item Description
[AUX] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to an AUX equipment.
M] [PAL-N] [SECAM]
[Camera] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to a rear view camera.
M] [PAL-N] [SECAM]
[TV] Select the suitable video signal setting when you connect
[Auto] [PAL] [NTSC] [PAL- this product to a TV tuner.
M] [PAL-N] [SECAM]
41
En