Clean The Print Roller; Clean The Printhead; Clean The Label Photocell - Carl Valentin VARIO III Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Vario III

Clean the Print Roller

A

Clean the Printhead

Printing can cause accumulation of dirt at the printhead e.g. by colour particles of the transfer ribbon, and therefore it is
necessary to clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.
CAUTION!
Printhead can be damaged!

Do not use sharp or hard objects to clean the printhead.

Do not touch the protective glass layer of the printhead.
•
Open the printer cover.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the label printer.
•
Clean the printhead surface with a special cleaning pen or a cotton swab dipped in pure alcohol.
•
Before using the label printer, let the printhead dry for about two to three minutes.

Clean the Label Photocell

CAUTION!
Label photocell can be damaged!

Do not use sharp or hard objects or solvents to clean the label photocell.
A
116
B C
B
A soiled print roller can lead to a reduced print quality and can
affect the transport of material.
CAUTION!
Print roller can be damaged!

Do not use sharp or hard objects to clean
the print roller.
•
Open the printer cover.
•
Turn the lever (C) counter clockwise to lift up the printhead
(B).
•
Remove labels and transfer ribbon from the label printer.
•
Remove deposits with the roller cleaner and a soft cloth.
•
Turn the roller (A) manually step by step to clean the
complete roller (only possible when printer is switched off,
as otherwise the step motor is full of power and the roller is
kept in its position).
The label photocell can be soiled with paper dust. This may
affect the label scanning.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove labels and transfer ribbon from the label printer.
•
Blow out the photocell (A) with the compressed air
spray. You have strictly to observe the instructions
mentioned on the can.
•
Moisten a cleaning card (B) with printhead and roll
solvent to clean additionally the photocell inside.
•
Reload labels and transfer ribbon.
English