Set The Cutting Height; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks Pro ULTRA POWER 60V LMC05 Manual Del Operador

EN
7.6

SET THE CUTTING HEIGHT

The machine can be set to different cutting heights.
1. Push the height adjustment button (6), move the height
adjust gear to a higher position to increase the cutting
height.
2. Push the height adjustment button, move the height adjust
gear to a lower position to decrease the cutting height.
7.7

INSTALL THE BATTERY PACK

7
15
English
6
13
14
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door (7).
2. Align the lift ribs on the battery pack (13) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
The motor starts only when you put in the safety key (14).
7.8

REMOVE THE BATTERY PACK

1. Open the battery door (7).
2. Remove the safety key (14).
3. Push and hold the battery release button (15).
4. Remove the battery pack from the machine.
8

OPERATION

Wear eye protection during operation.
8.1

START THE MACHINE

1
2
1. Put in the safety key.
2. Push and hold the start button (2).
10
WARNING
NOTE
WARNING