Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
SPECIFICATIONS
Model
Motor
Power Source
Current
Full-load Impact Rate
Weight
APPLICATIONS
○
Demolishing concrete, chiseling concrete, grooving,
bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1.
Power source
Ensure that the power source to be utilized conforms
to the power source requirements specifi ed on the
product nameplate.
2.
Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3.
Extension cord
When the work area is far away from the power source,
use an extension cord of suffi cient thickness and rated
capacity. The extension cord should be kept as short
as practicable.
WARNING
Damaged cord must be replaced
or repaired.
4.
Check the receptacle
If the receptacle only loosely accepts the plug, the
receptacle must be repaired. Contact a licensed
electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause
overheating, resulting in a serious hazard.
5.
Confi rming condition of the environment:
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
6
ASSEMBLY AND OPERATION
H41MB2
Single-Phase, Series Commutator Motor
Single-Phase, 120 V AC 60 Hz
8.4 A
3000 /min
11.5 lbs (5.2 kg)
6.
Installing the Side Handle
(1) Turn the side handle to dismantle. (Fig. 2)
Handle bolt
Band
(2) Place the band over the band attachment area and fi t
the band's two holes onto the "T" portion of the handle
bolt. (Fig. 3, 4)
Band
Side handle
Mount
Fig. 2
Band attachment area
Fig. 3
Handle bolt
Fig. 4
Publicidad
Tabla de contenido
