Assembly And Operation; Intend Use; Prior To Operation; Basic Functions - Metabo HPT RH 650V Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

ASSEMBLY AND OPERATION

INTEND USE

When observing the safety rules and using
the original accessories, this hot air tool is
intended for all applications with hot air that
are listed in these operating instruction.
Applications
Shrinking of shrink down tubing, solder
connectors and solder terminals,
packaging and electrical components.
Deforming of articles made from acrylic,
PVC, and polystyrene, tubing, plates and
profiles, as well as moist woods.
Welding of thermoplastic polymer,
flooring materials of PVC and linoleum,
PVC-coated fabric, tarpaulins and foils.
Soldering of tin, special silver solder,
SMD elements, cable lugs, and for
loosening soldered connections.
Paint removal –Removal of old and even
thick coatings of oil paint, varnish and
synthetic plaster.
Drying of colour shade samples, filter,
adhesives, construction joints and
stucco forms.
Joining adhesives-Large-surface gluing
with contact adhesives, activation of
pressure-sensitive
acceleration of bonding processes,
releasing of bonding points as well as
releasing or bonding of edge bond or
veneer.
Defrosting of icy stairs and steps, door
locks, trunk lids, car doors or water pipes,
as well as for defrosting refrigerators and
ice boxes.
Disinfection-With hot air of 1,110 °F
(600 °C), you can quickly rid animal sties/
stables of bacteria. Woodworm
infestation can be controlled (Caution:
Danger of fire! Do not heat up the
wooden surface excessively).
8

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be
utilized conforms to the power source
requirements specified on the product
nameplate.
2. Power switch
Ensure that the switch is in the OFF
position. If the plug is connected to a
receptacle while the switch is in the ON
position, the power tool will start
operating immediately and can cause
serious injury.
3. Extension cord
When the work area is remote from the
power source, use an extension cord of
sufficient thickness and rated capacity.
The extension cord should be kept as
short as practicable.
4. Check the receptacle
If the receptacle only loosely accepts the
plug, the receptacle must be repaired.
adhesives,
Contact a licensed electrician to make
appropriate repairs.
If such a fautly receptacle is used, it may
cause overheating, resulting in a serious
hazard.

BASIC FUNCTIONS

1. Switch Operations and Temperature
Adjustments (Fig.1, 2)
Slide the knob upward to activate the
switch and enable continual operations
even when your finger is removed.
Slide the knob downward as far as it will
go to set the switch at the [0] position
and turn it off.
WARNING:
Damaged cord must be
replaced or repaired.

Publicidad

Tabla de contenido
loading

Tabla de contenido