Hitachi C10FCH2 Manual De Instrucciones página 9

Steel
Holder
square
(Optional
accessory)
6mm Wing
nut (Optional
accessory)
Height adjustment
bolt 6mm (Optional
accessory)
4. Stopper for precision cutting ... (Stopper and holder are optional
accessory)
The stopper facilitates continuous precision cutting in lengths of 11"
to 17-3/4" (280mm to 450mm).
To install the stopper, attach it to the holder with the 6mm wing bolt
as shown in Fig. 10.
Stopper
(Optional accessory)
Workpiece
Holder
(Optional accessory)
Move
6mm Wing bolt
(Optional accessory)
Fig. 10
5. Confirmation for use of sub fence (B) ...(Standard accessory)
WARNING:
In the case of left bevel cutting, rotate the sub fence (B). Supposing
it is not able to rotate it, It will contact the blade or some part of the
tool, causing in serious injury to operator.
Sub fence (B)
Fence (B)
Fig. 11
6. Position adjustment of laser line (Only Model C10FCH2)
WARNING:
* Make sure before plugging the power plug into the receptacle
that the main body and the laser marker are turned off.
* Exercise utmost caution in handling a switch trigger for the
position adjustment of the laser line, as the power plug is plugged
into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can
rotate and result in unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
6mm Wing bolt
(Optional accessory)
Base surface
Fig. 9
6mm Wing nut
(Optional accessory)
Height adjustment bolt 6mm
(Optional accessory)
CAUTION:
Fig. 12
Fig. 13
* Laser radiation — Do not stare into beam.
* Laser radiation on work table. Do not stare into beam.
If your eye is exposed directly to the laser beam, it can be hurt.
* Do not dismantle it.
* Do not give strong impact to the laser marker (main body of tool);
otherwise, the position of a laser line can go out of order, resulting
in the damage of the laser marker as well as a shortened service
life.
* Keep the laser marker lit only during a cutting operation.
Prolonged lighting of the laser marker can result in a shortened
service life.
* Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
NOTE:
* Perform cutting by overlapping the ink line with the laser line.
* When the ink line and the laser line are overlapped, the strength
and weakness of light will change, resulting in a stable cutting
operation because you can easily discern the conformity of lines.
This ensures the minimum cutting errors.
* In outdoor or near-the-window operations, it may become difficult
to observe the laser line due to the sunlight. Under such
circumstances, move to a place that is not directly under the
sunlight and engage in the operation.
* Do not tug on the cord behind the motor head or hook your finger,
wood and the like around it; otherwise, the cord may come off
and the laser marker may not be lit up.
Ink lining can be easily made on this tool to the laser marker. A
switch lights up the laser marker. (Fig. 14)
Depending upon your cutting choice, the laser line can be aligned
with the left side of the cutting width (saw blade) or the ink line on
the right side.
English
9