Samsung WA50M7450A Serie Manual De Usuario página 15

Ocultar thumbs Ver también para WA50M7450A Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Connect the ends of the water supply hoses to the HOT and COLD
faucets.
2. Tighten the fi ttings by hand until they are snug, and then tighten them an
additional two-thirds of a turn with a plier.
CAUTION
3. Place the unconnected ends of the hoses into a bucket and open the
faucets connected to the two water supply hoses for 10 or 15 seconds to
remove any foreign substances from the hoses. Close the faucets before
continuing.
4. Connect the ends of the water supply hoses to the water supply intake
connections at the back of the washer.
CAUTION
5. Tighten the fi ttings by hand until they are snug, and then tighten them
an additional two-thirds of a turn with a plier.
CAUTION
6. Turn on the HOT and COLD water supplies and check all the water
supply intake connections and the faucets for water leaks.
WA7000M_DC68-03774A-03_EN.indd Sec3:15
WA7000M_DC68-03774A-03_EN.indd Sec3:15
When you fasten the fi ttings, do not fasten them too tightly or apply
tape or sealant to the faucets or water supply intakes. This can
damage the fi ttings.
After you have connected the water supply hoses to the faucets,
ensure that they are connected correctly by pulling the water supply
hoses downwards
The water supply hose connected to the HOT faucet must be
connected to the hot water supply intake and the water hose
connected to the COLD faucet must be connected to the COLD
water supply intake.
To ensure the correct water usage, connect both the HOT and
COLD water faucets. If either or both are not connected, an "4E"
(no fi ll) error can occur.
If you do not want to use the HOT water supply hose, insert
the water intake cap into the HOT water supply intake hole. In
this case, you must select the Tap Cold option for the water
temperature. If you select the Tap Cold option, all the lamps for
the water temperature options are turned off .
Confi rm that the water supply hoses are not twisted or bent. If the
hoses are twisted or bent, the hoses can leak and cause electric
shock due to the water leakage.
English - 15
4/12/2018 3:43:37 PM
4/12/2018 3:43:37 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wa45m7050a serieWa50n7350a serieWa45n7150a serie

Tabla de contenido